Rollverine Roll Groover

Description

Rollverine Roll Groover. Shipped with UPS Ground and most of the parts will come via a large flat rate box.
This roll Grover is patterned after the RIGID 975 roll groover. This one uses strong huge ball bearings instead of the bushings that rigid uses. It also does not have a gear reduction system to allow you to use it by hand. That is to say, it requires a pipe threading tool to use. It also uses a small hydraulic jack to press on the workpiece rather than a screw.
This is the last one produced and has been sitting under a shelf for a couple of years. There are enough extra parts here to last a lifetime. Please note that there are some non-critical defects and one other defect.
-on the assembled unit, the plate that the jack pushes on to increase the roll depth has a broken weld.
-on the yellow piece that doesn’t have a picture by itself, there is a tap broken off in the hole that keeps the pin for the roller tool. This piece is included so that the four not painted metal brackets have a reference to how they should be made.
The parts included should allow this tool to be rebuilt at least 4 times. There are more parts available, if you needed more down the road.